Grab a couple of mates and give Karim a call on 02 6235 5622 to arrange something that does fit with you. Minimum numbers for a custom course depends on the course - 3 for Bladsmithing and Knifemaking, 2 for Damascus, 4 for Father and Son Blacksmithing, 4 for Sharpening. Prices are the same as the other courses.
We'll be only too happy to help.
Home
See by year
See by month
See by week
See Today
Search
Jump to month
Sharpening
Thursday, 26 February 2009, 19:30 - 22:00
A sharp knife is much safer than a blunt one. It cuts cleanly and does not slip, causing few accidents. Yet most people don’t know how to sharpen a knife and keep it sharp. This evening course, run by Bladesmith Karim Haddad, shows you the secrets of getting and maintaining a fine edge. Five different methods will be demonstrated in setting an edge as well as burr removal honing and touching up. Knife care and storage will also be covered to ensure you knife stays sharp. This will be followed with a practical session where you get to sharpen the knives that you have brought with you.
Cost is $75 for the evening – 7:30pm until 10:00pm.
There is a maximum of only six participants per class.
Location: Tharwa Valley Forge Contact: CIT Solutions 6207 4444
This intensive weekend course is an introduction to Pattern Welded or Damascus steel. You will learn techniques in welding, folding and patterning beautiful and unique steel. We'll be using a hydraulic power press and rolling mill to make the welds and draw down the billets. You will make two billets and two forged blades to keep and finish into knives. The billets will allow you to make a number of other knives in the future either by forging or stock removal.
The course goes from Saturday morning until Sunday Afternoon. For starting dates of next courses see the upcoming courses list on the side panel.
Cost - $880 (incl GST)
Some experience in knifemaking or blacksmithing is an advantage for the course.
Tharwa Valley Forge is pleased to offer our propane powered knife making forges. These forges are the same design as used in our courses. Dimensions are 30cm long with a 24cm wide barrel chamber. Custom sizes are available on request. The forges come fully lined with a gas burner and fittings. You just nned to add a gas bottle. It gets up to welding temperature in 10 minutes and has a good reducing atmosphere for forging Damascus. Clean, compact and fast way to forge your own blades.
This intensive weekend course is an introduction to Pattern Welded or Damascus steel. You will learn techniques in welding, folding and patterning beautiful and unique steel. We'll be using a hydraulic power press and rolling mill to make the welds and draw down the billets. You will make two billets and two forged blades to keep and finish into knives. The billets will allow you to make a number of other knives in the future either by forging or stock removal.
Tharwa Valley Forge is pleased to offer our propane powered knife making forges. These forges are the same design as used in our courses. Dimensions are 30cm long with a 24cm wide barrel chamber. Custom sizes are available on request. The forges come fully lined with a gas burner and fittings. You just nned to add a gas bottle. It gets up to welding temperature in 10 minutes and has a good reducing atmosphere for forging Damascus. Clean, compact and fast way to forge your own blades.
